Đặc tính kỹ thuật của VigorIPPBX 3510
|
Hardware Interface |
LAN |
4-port 10/100 LAN, RJ-45 |
VigorIPPBX 3510 |
WAN |
1-port 10/100 WAN, RJ-45 |
|
USB |
1-port USB host 2.0 for storage |
|
VoIP |
4-port FXS module |
|
(2-port Interface card slot) |
4-port FXO module |
|
|
S0/TE module * |
|
|
ALL TE module * |
|
Reset |
1 Factory reset button |
IP PBX Features |
6 IP accounts |
100 accounts (extensions) |
Registration and authentication |
1 levels AA |
Hunting group (10) |
IVR |
Time Scheduling |
Dial plan (digi-map) |
Session monitor |
Call detail records |
DID |
Extension privilege assign |
PIN code control |
Call barring |
Call routing |
Call park |
Call pickup |
Call forwarding |
Call transfer |
In/Out band call through FXO interface |
User defined prompts |
Voice message to e-mail |
Voice mail |
MWI |
Music on hold |
1 conference bridge * |
ISDN features |
ISDN Failover (Loop through) [available on 2 TE/NT(S0) interface module] |
ISDN On-Net/Off-Net |
10 MSN (Multiple Subscriber Numbers) on each ISDN S0 port for VoIP Call |
Signaling compliance : ITU-T Rec. Q. 920, Q921, Q930, Q931 |
FAX/Modem support |
Tone detection |
G.711 pass-through |
T.38 for FAX |
WAN protocol |
Ethernet |
PPPoE, PPTP, DHCP client, static IP, L2TP, BPA |
ISDN |
DSS1 (Euro ISDN), PPP, ML-PPP(64/128Kbps) |
Dual WAN |
Outbound policy based Load balance |
Allow your local network to access Internet using multiple INternet connections with high-level of Internet connectivity availability |
Two dedicated Ethernet WAN ports (10/100Mb/s) |
WAN fail-over or load-balanced connectivity |
Bandwidth on Demand |
Service/IP based preference rules or auto-weight |
VPN |
Protocols |
PPTP, IPSec, L2TP, L2TP over IPSec |
Up to 32 sessions simultaneously |
LAN to LAN, remote access (teleworker-to-LAN). doa;-in or dial-out |
VPN throughput |
50Mbps |
NAT-Traversal (NAT-T) |
VPN over routes without VPN pass-through |
PKI certificate |
Digital signature (X.509) |
IKE authentication |
Pre-shared key; IKE phase 1 aggressive/standard modes & phase 2 selectable lifetimes |
Authentication |
Hardware-based MD5, SHA-1 |
Encryption |
MPPE and hardware-based AES/DES/3DES |
RADIUS client |
Authentication for PPTP remote dial-in |
DHCP over IPSec |
Because DrayTek add a virtual NIC on the PC, thus, while connecting to the server via IPSec tunnel, PC will obtain an IP address from the remote side through DHCP protocol, which is quite similar with PPTP |
Dead Peer Detection (DPD) |
When there is traffic between the peers, it is not necessary for one peer to send a keep-alive to check for liveness of the peer because the IPSec traffic serves as implicit proof of the availability of the peer |
Smart VPN software utility |
Provided free of charge for teleworker convenience (Windows environment) |
Easy of adoption |
No additional client or remote site licensing required |
Industrial-standard interoperability |
Compatible with other leading 3rd part vendor VPN devices |
Content filter |
URL keyword blocking |
Whitelist and Blacklist |
Java applet, cookies, active X, compressed, executable, multimedia file blocking |
Web content filter |
Dynamic URL filtering database |
Time schedule control |
Set rule according to your specific office hours |
Firewall |
Stateful Packet Inspection |
Outgoing/Incoming traffic inspection based on connection information |
VigorIPPBX 3510 |
Content Security Management |
Appliance-based gateway security and content filtering |
|
Multi-NAT |
You have been allocated multiple public IP address by your ISP. You hence can have a one-to-one relationship between a public IP address and an internal/private IP address. This means that you have the protection of NAT (see earlier) but the PC can be addressed directly from the outside world by its aliased public IP address, but still by only opening specific ports to it (for example TCP port 80 for an http/web server) |
|
Port redirection |
The packet is forwarded to a specific local PC if the port number matches with the defined port number. You can also translate the external port to another port locally |
|
Open ports |
As port redirection (above) but allows you to defined a range of ports |
|
DMZ host |
This opens up a single PC completely. All incoming packets will be forwarded onto the PC with the local IP address you set. The only exceptions are packets received in response to outgoing requests from other local PCs or incoming packets which match rules in the other two methods. |
|
The precedence is as follows : Port Redirection > Open Ports > DMZ |
|
Policy-based IP packet filter |
The header information of an IP packet (IP or Mac source/destination addresses; source/destination ports DiffServ attribute; direction dependent, bandwidth dependent, remote-site dependent |
|
DoS/DDoS prevention |
Act of preventing customers, users, clients or other computer from accessing data on a computer |
|
IP address anti-spoofing |
Source IP address check on all interface: only IP addresses classified within the defined IP networks are allowed |
|
Object-based firewall |
Utilizes object-oriented approach to firewall policy |
|
Notification |
E-mail alert and logging via syslog |
|
Bind IP to MAC address |
Flexible DHCP with 'IP-MAC binding' |
|
WDS security |
The us of authentication and encryption techniques on a Wireless Distribution System (WDS) link between compatible access points |
System management |
Web-based user interface (HTTP/HTTPS) |
Integrated web server for the configuration of routers via Internet browsers with HTTP or HTTPS |
DrayTek's Quick Start Wizard |
Let administrator adjust time zone and promptly set up the Internet (PPPoE, PPTP, Static IP, DHCP) |
User administration |
RADIUS user administration for dial-in access (PPP/PPTP and ISDN CLIP) |
CLI (Command Line Interface, Telnet/SSH) |
Remotely administer computers via the telnet |
DHCP client/relay/server |
Provides an easy-to configure function for your local IP network |
Dynamic DNS |
When you connect to your ISP, by broadband or ISDN you are normally allocated an dynamic IP address. i.e. the public IP address your router is allocated changes each time you connect to the ISP. If you want to run a local server, remote users cannot predict your current IP address to find you |
Administration access control |
The password can be applied to authentication of administrators |
Configuration backup/restore |
If the hardware breaks down, you can recover the failed system within an acceptable time. Through TFTP, the effective way is to backup and restore configuration between remote hosts. |
Port-based VLAN |
Create separate groups of users via segmenting each of the Ethernet ports. Hence, they can or can't communicate with users in other segments, as required |
Built-in diagnostic function |
Dial-out trigger, routing table, ARP cache table, DHCP table, NAT sessions table, wireless VLAN online station table, data flow monitor, traffic graph, ping diagnosis, trace route |
NTP client/call scheduling |
The Vigor has real time clock which can update itself from your browser manually or more conveniently automatically from an Internet time server (NTP). This enables you to schedule the router to dial-out to the Internet at a preset time, or restrict Internet access to certain hours. A schedule can also be applied to LAN-to-LAN profiles (VPN or direct dial) or some of the content filtering options |
Firmware upgrade via TFTP/HTTP/FTP |
Using the TFTP server and the firmware upgrade utility software, you man easily upgrade to the latest firmware whenever enhanced features are added |
ISDN remote maintenance |
The system manager can remotely manage the routers through an ISDN remote dial-in with secure call back mechanism |
Remote maintenance |
With Telnet/SSL, SSH (with password or public key), browser (HTTP/HTTPS), TFTP or SNMP, firmware upgrade via HTTP/HTTPS of TFTP |
Wake on LAN |
A PC on LAN can be woken up from an idle/stand by state by the router it connects when it receives a special 'wake up' packet on its Ethernet interface |
Logging via syslog |
Syslog is a method of logging router activity |
SNMP management |
Tag: VigorIPPBX3510 |
Hỏi và đáp (0 bình luận)